How To Fix A Wet Cell IPhone

vipfixphone
Jun 19, 2017
2 min read

Introduction This guide will offer you the detailed instructions on how to fix a wet cell IPhone. Follow the step-by-step repair instructions ，We’ll get your iPhone looking brand new again in no time! All the DIY repair parts and tools used in this guide can be found here.

Steps 1. Remove the battery immediately: This will stop current flowing freely in the PCB. 2. Disassemble your cell phone: Use ***to open up your cell phone carefully. You can see videos of dismantling method for your particular model on YouTube! 3. Dry the circuit board completely: You can use a hair drier or sunlight to dry it immediately and completely. 4. You have to make sure that all the spare parts and components are dried: You also need to dry the components as well as the body so that nothing remains wet. Be careful that you do not break the LCD as it is very delicate. 5. Clean the circuit board: Clean the entire PCB with alcohol using a brush. This will prevent corrosion on the PCB. 6. Reassemble your phone to check if your phone switches on. If yes,

7. your iPhone can be well used again. If no, don’t get dejected. You can connect it to computer and see if it is getting detected. If yes, update it online and check again. If it does not switch on, charge your handset and try again. And if it is not getting detected in computer, dismantle your handset again and give mild heat (not more than mild!) all over the PCB and check again. If it doesn’t switch on now, you will have to visit a repair center.

Note: If you do not know how to go about the above procedures, don’t repair it yourself. You are more likely to damage the handset further. Just remove the battery immediately when it falls in get it fixed at repair centers.